This website collects user information at several different points in order to process your business inquiries, provide product information, and better serve you. Information collected typically includes your name, company name, email address, telepho
Operation and use of desilter Desilter operation and use: ①Start the small vibrating screen first, then start the desilter pump, check the discharge pressure of the desilter pump Whether the force meets the requirements, check the desilting effect, and check that the cyclone has There is no leakage. ②Check whether the direction of the motors steering is consistent with the direction of the arrow on the shield, no The vibrating screen will not discharge sand. ③Check whether the pressure of the pressure gauge is within the working pressure range (0.2~ 0.4MPa) ④ The screen is tightened and replaced by hinge bars at both ends and tightened; ⑤Amplitude adjustment: Open the hood first, and set the eccentric blocks at both ends of the motor shaft in the same direction The same angle adj
Operation and use of desilter Read More »
Desanding cyclone/cleaner (ZJQ300 X2– 1.6X0.6) 1. Principle: Desanding cleaner is the second level solid of oil drilling engineering Control equipment, which can separate 20~50m sand grains defined by API. 2. Features: 1) The de-sand cleaner has a co
Desanding cyclone/cleaner Read More »
Features of Maganetic Agitator: Magnetic Agitator is actually a radical reform and innovation upon conventional stirred tank reactor since shaft in the tank no longer group drives with output shaft of electric motor nor is the packing seal
Difference between Magnetic Agitator and Mud Agitator Read More »
Improper gear meshing means that continuous, clear noise is generated by too small or big gap between meshes, incorrect meshing sites, inadequate meshing area and will raise when rotating speed increases; improper bearing assembly describes
Learn to tell the causes for noises in retarder assembly Read More »
1. For the first time, replace the oil after one-cycle operation. And replace it every 3-6 months later on. If the temperature goes too high or too humid, remember to shorten the period and to add oil. 2. Retarder is not lubricated when lea
Brief introduction on retarder selection and maintenance Read More »
Common Ways for Speed Reducer to Treat Oil Leakage: I. Reparation: Take some as examples, scrape it if the joint surface of Worm Speed Reducer case cover is not closely sealed. Repair the tubing flare when oil leakage occurs at the tubing c
Common Ways for Speed Reducer to Treat Oil Leakage Read More »
1. Steel or cast iron pads are applicable for retarder calibration, usually three pads are enough. Carved iron is another choice, but flat pad should replace it after calibration. 2. Water-based drilling fluids should irrigate intensively w
Ways to Install Planet-Cycloid Retarder Read More »
Economy of Shale Shaker ： KOSUN Linear Shale Shaker has an obvious edge on treatment of large capacity drilling fluids. Under such circumstances, it generates strong vibrating power which removes the multitude of solid phase via effective
Maintenance and Keep-up of KOSUN OZS703 Read More »
