- Home
- Products
-
-
Solids Control Equipment
- Linear Motion Shale Shaker
- Decanter Centrifuge
- Mud Cleaner
- Vacuum Degasser
- Centrifugal Pump
- Shear Pump
- Submersible Slurry Pump
- Mud Agitator
- Mud Gun
- Jet Mud Mixer
- Desilter
- Water Tank
- Mud Tank
- LS1850 Shale Shaker
- Diesel Tank
- MD210 Drilling Mud Cleaner
- Balanced Elliptical Motion Shale Shaker
- Oilfield Drilling Mud Desander
-
Solids Control System
- Drilling Mud Cooling System
- Solids Control System
- Mobile Solids Control System
- Arctic Solids Control System
-
TBM
- Tunnel Boring Mud System
-
HDD
- HDD Mud Recovery System
-
-
- News
- Services
- Marketing
- About Us
- Contact Us
- Videos
Home > KOSUN News >
What are the parts prone to failure during the use of solid control equipment
Nov 18, 2024
Solid control equipment itself is by a lot of equipment to complete the task, the development trend of solid control equipment in China is very stable, because solid control equipment is a very important equipment in the solid phase control of oil drilling, the utilization rate of solid control equipment is very high, so it is inevitable to produce failures, below we will talk about what parts of the problem in the failure of solid control equipment. What are the causes and solutions to these problems?
The slurry vibrating screen of solid control equipment sometimes fails to run drilling fluid, mainly because the drilling fluid displacement is greater than the load of the vibrating screen, the viscosity of the drilling fluid is too high, the sieve mesh number can not leak down or the drilling fluid is mixed with a large number of fiber substances, affecting the drilling fluid leakage, or it may be because the sieve cloth is not washed in time after the drilling stop circulation. The drilling fluid dried the sieve cloth to death, and only when we use these problems in time to prevent them from happening.
Mud shaker
Sometimes in solid control equipment, the desander and desilter swirl funnel will be blocked, causing the equipment to be unable to use, which is the reason for the unreasonable use of mud vibrating screen or screen damage, followed by the sand pump and desilter pump upper water pipe is not installed filter screen, large particles of rock debris into the swirl funnel caused by blocking. Therefore, we must ensure that the installation position is reasonable and the installation parts are complete when we use them.
Solid control equipment in the use of drilling fluid mixer is often damaged a equipment, the main reason is that in the use of drilling fluid density, high viscosity, mixer power is low, resulting in the use of overload, can not adhere to continuous operation. If there is no timely maintenance and lubrication and installation is not reasonable, it will also cause this phenomenon. Therefore, we must pay more attention to the maintenance and repair of the equipment, and the regular operation method can be exchanged for the normal use efficiency.
